Cisco Systems ME3600X24FSM, ME 3600X 24CX manual Return

Initial Setup

Step 6 (Optional) Configure Simple Network Management Protocol (SNMP) by responding to the prompts. You can also configure SNMP later through the CLI. To configure SNMP later, enter no.

Configure SNMP Network Management? [no]: no

Step 7 At the prompt, enter either FastEthernet0 or the VLAN name (usually VLAN1) as the interface connected to the management network, and press Return.

Enter interface name used to connect to the

management network from the above interface summary: FastEthernet0

Step 8	Enter Yes after the prompt, and then enter the	Configuring interface vlan1:
	switch IP address and subnet mask. Press	Configure IP on this interface? [yes]: yes
	Return.	IP address for this interface: 10.4.120.106
	The IP address and subnet mask shown to the	Subnet mask for this interface [255.0.0.0]: 255.0.0.0
	right are examples.
Step 9
	Enter N when the prompt asks if you want to	The following configuration command script was created:
	enable the switch as a cluster command switch.	hostname switch1
	This switch will be a standalone switch that	enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
		enable password enable_password
	does not support clustering.
		line vty 0 15
	Would you like to enable as a cluster	password terminal-password
		no snmp-server
	command switch? [yes/no]: no
		!
	The switch displays its initial configuration, as	no ip routing
	shown on the right.	!
		interface Vlan1
		no shutdown
		ip address 10.4.120.106 255.0.0.0
		!
		interface FastEthernet0/1
		!
		interface FastEthernet0/2
		...<output abbreviated>
		interface FastEthernet1/0/3
		!
		interface GigabitEthernet0/1
		!
		interface GigabitEthernet0/2
		!
		end

Step 10 These choices appear:

[0]Go to the IOS command prompt without saving this config.

[1]Return back to the setup without saving this config.

[2]Save this configuration to nvram and exit.

If you want to save the configuration and use it the next time the switch reboots, save it in NVRAM by selecting option 2.

Enter your selection [2]:2

Make your selection, and press Return.

Cisco ME 3600X-24CX Switch Getting Started Guide

OL-27508-01 5