Cisco Systems ME3600X24FSM, ME 3600X 24CX manual Initial Setup

Initial Setup

Initial Setup

You need this equipment:

•PC

•Straight-through or crossover Category 5 Ethernet cable

Step 1 Obtain this information from your network administrator before you start the setup program:

•Switch IP address

•Subnet mask (IP netmask)

•Default gateway (router)

•Enable secret password

•Enable password

•Telnet password

Step 2 Connect the adapter cable to the console connector on the switch front panel. Connect the other end of the cable to the Ethernet port on your DHCP-enabled PC.

You must supply the console cable if you did not order one with your switch.

333305

Step 3	Start a terminal-emulation application such as Hyperterminal or ProcommPlus.
Step 4
	Configure the baud rate and character format of the PC or	•	9600 baud
	terminal to match these console port default characteristics.	•	8 data bits
		•	1 stop bit
		•	No parity
		•	None (flow control)
Step 5
	Power the switch.

AC power switches: Plug the AC power cord into the switch power supply and into a grounded AC outlet. Set the power supply switch to ON.

DC power switches: See the wiring instructions in the hardware installation guide on Cisco.com.

Cisco ME 3600X-24CX Switch Getting Started Guide

OL-27508-01 3