Cisco Systems ME 3400 manual Installing SFP Modules, SFP Module with a Bale-Clasp Latch

Chapter 2 Switch Installation

Installing and Removing SFP Modules

Installing SFP Modules

Figure 2-12shows an SFP module that has a bale-clasp latch.

Caution We strongly recommend that you do not install or remove fiber-optic SFP modules with cables attached because of the potential damage to the cables, the cable connector, or the optical interfaces in the SFP module. Disconnect all cables before removing or installing an SFP module.

Removing and installing an SFP module can shorten its useful life. Do not remove and insert SFP modules more often than is absolutely necessary.

Figure 2-12 SFP Module with a Bale-Clasp Latch

86575

To insert an SFP module into the module slot, follow these steps:

Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.

Some SFP modules identify the top side of the module with send (TX) and receive (RX) markings or arrows that show the direction of the connection.

Step 2 If the SFP module that you are using has the markings, use them to identify the top side of the module. Step 3 Align the SFP module in front of the slot opening.

Step 4 Insert the SFP module into the slot until you feel the connector on the module snap into place in the rear of the slot (see Figure 2-13).

Figure 2-13 Installing an SFP Module into an SFP Module Slot

Cisco ME

1

2

3400 SERIES

132674

Cisco ME 3400 Ethernet Access Switch Hardware Installation Guide

OL-7677-04 2-17