Cisco Systems MPC-273 manual Configuring Inter-AS and CSC support over IP Tunnels, end or commit

Implementing MPLS VPNs over IP Tunnels on Cisco IOS XR Software

How to Configure MPLS VPNs over IP Tunnels

Configuring Inter-AS and CSC support over IP Tunnels

These tasks describe how to configure Inter-AS and CSC support over IP tunnels:

•Configuring the ASBRs to Exchange VPN-IPv4 Addresses for IP Tunnels, page MPC-285(required)

•Configuring the Backbone Carrier Core for IP Tunnels, page MPC-288

•Configuring CSC-PE Routers for IP Tunnels, page MPC-288

Configuring the ASBRs to Exchange VPN-IPv4 Addresses for IP Tunnels

Perform this task to configure an external Border Gateway Protocol (eBGP) autonomous system boundary router (ASBR) to exchange VPN-IPv4 routes with another autonomous system for IP tunnels

Note This procedure is supported on the Cisco XR 12000 Series Router.

SUMMARY STEPS

1.configure

2.router bgp autonomous-system-number

3.address-family {ipv4 tunnel}

4.address-family {vpnv4 unicast}

5.neighbor ip-address

6.remote-asautonomous-system-number

7.address-family {vpnv4 unicast}

8.route-policyroute-policy-name {in}

9.route-policyroute-policy-name {out}

10.neighbor ip-address

11.remote-asautonomous-system-number

12.update-sourceinterface-type interface-number

13.address-family {ipv4 tunnel}

14.address-family {vpnv4 unicast}

15.end or commit

	Cisco IOS XR MPLS Configuration Guide
OL-12284-01		MPC-285