Cisco Systems OL-1911-05 manual Pd pd rx-cttr index tx-cttr index interface, 24-17

Chapter 24 Configuring ATM Router Module Interfaces

Configuring Multiprotocol Encapsulation over ATM

Note Traffic shaping and policing are not supported on the ATM router module interfaces; for traffic shaping and policing on ATM connections, use VP tunnels. For more information on VP tunnels, see Chapter 6, “Configuring Virtual Connections.”

To configure multiprotocol encapsulation over ATM on the ATM router module interface, use the following commands, beginning in global configuration mode:

	Command	Purpose
Step 1
	Switch(config)# interface atm	Creates the ATM router module
	card/subcard/port.subinterface# multipoint	point-to-multipoint subinterface and enters
	Switch(config-subif)#	subinterface mode.
		Note The ATM router module only supports
		point-to-multipoint subinterfaces.
Step 2 Switch(config-subif)# ip address ip-address mask		Enters the IP address and subnet mask associated
		with this interface.
Step 3
	Switch(config-subif)# map-groupname	Enters the map group name associated with this
		PVC.
Step 4 Switch(config-subif)# atm pvc 2 vci-a[upc upc]		Configures the PVC.
	[pd pd] [rx-cttr index] [tx-cttr index] interface	Note The VPI number on the ATM router
	atm card/subcard/port[.vpt#] vpi-b vci-b
		module interface must be 2.
	[upc upc] encap {aal5mux1 aal5snap}
Step 5	Switch(config-subif)# exit	Returns to global configuration mode.
	Switch(config)#
Step 6
	Switch(config)# map-listname	Creates a map list by naming it, and enters
	Switch(config-map-list)#	map-list configuration mode.
Step 7
	Switch(config-map-list)# ip ip-address	Associates a protocol and address with a specific
	{atm-nsap address atm-vc vci} [broadcast]	virtual circuit.

1.Only the Catalyst 8540 MSR enhanced ATM router module supports AAL5 MUX encapsulation.

Example

The following example shows how to configure RFC 1483 on an ATM router module interface, beginning in global configuration mode:

Switch(config)# interface atm 1/0/0.1011 multipoint

Switch(config-subif)#ip address 10.1.1.1 255.255.255.0

Switch(config-subif)# map-group net1011

Switch(config-subif)#atm pvc 2 1011 interface atm 3/0/0 0 1011 encap aal5snap

Switch(config-subif)# exit

Switch(config)# map-list net1011

Switch(config-map-list)# ip 10.1.1.2 atm-vc 1011

Switch(config-map-list)# end

Switch#

	ATM and Layer 3 Switch Router Software Configuration Guide
OL-1911-05		24-17