Chapter 24 Configuring ATM Router Module Interfaces

Configuring Bridging

Switch(config)# interface atm 3/0/0

Switch(config-if)#atm pvc 2 200 interface atm 1/0/0 0 200

Switch(config-if)# bridge-group 5

Switch(config-if)# end

Switch(config)# interface fastethernet 0/0/0

Switch(config-if)# no cdp enable

Switch(config-if)# bridge-group 5

Switch(config-if)# end

Switch(config)# bridge 5 protocol ieee

Configuring Packet Flooding on a PVC

Typically, a specific static map list configuration is not required for bridging to occur. In case of packet flooding, the bridging mechanism individually sends the packet to be flooded on all PVCs configured on the interface. To restrict the broadcast of the packets to only a subset of the configured PVCs you must define a separate static map list. Use the broadcast keyword in the static-mapcommand to restrict packet broadcasting.

 

Command

Purpose

Step 1

 

 

Switch(config)# interface atm card/subcard/port

Specifies the interface to configure on the ATM

 

Switch(config-if)#

router module.

 

 

Step 2

 

 

Switch(config-if)# no ip address

Disables IP processing.

Step 3

 

 

Switch(config-if)#no ip directed-broadcast

Disables the translation of directed broadcasts to

 

 

physical broadcasts.

Step 4

 

 

Switch(config-if)# map-groupnumber

Enters the map group name associated with this

 

 

PVC.

 

 

 

Step 5 Switch(config-if)#atm pvc 2 vci-Ainterface atm

Configures a PVC.

 

card/subcard/port vpi-B

Note The VPI number on the ATM router

 

 

 

 

module interface must be 2.

Step 6

 

 

Switch(config-if)# bridge-groupnumber

Assigns the interface to a bridge group.

Step 7

 

 

Switch(config-if)# end

Returns to global configuration mode.

 

Switch(config)#

 

Step 8

 

 

Switch(config)# map-listname

Creates a map list by naming it, and enters

 

Switch(config-map-list)#

map-list configuration mode.

 

 

Step 9

 

 

Switch(config-map-list)# bridge atm-vcnumber

Enables packet flooding on a PVC.

 

broadcast

 

 

 

 

 

 

ATM and Layer 3 Switch Router Software Configuration Guide

 

 

 

 

 

 

OL-1911-05

 

 

24-25

 

 

 

 

 

Page 25
Image 25
Cisco Systems OL-1911-05 Configuring Packet Flooding on a PVC, Switchconfig-if# no ip directed-broadcast, Broadcast, 24-25