Chapter 2 Camera Installation
IP Camera Installation
Mounting the IP camera with a Vandal Resistant Enclosure
To mount the 3520 IP camera using a vandal resistant (VR) enclosure, complete the following steps:
Procedure
Step 1 Attach the included alignment sticker to the ceiling or wall.
Step 2 Using the circle marks on the sticker, drill at least 2 pilot holes symmetrically on each side into the ceiling or wall. Then hammer the included plastic anchors into the holes.
Step 3 Do one of the following:
•To feed cables through a ceiling or wall, cut out a section of the ceiling or wall that corresponds to the triangular cutout on the alignment sticker.
•To feed cables through the side of the conduit base, use a screwdriver to remove the cutout on the side of the conduit base.
Step 4 Secure the conduit base to the ceiling or wall with two included screws.
|
| Cisco Video Surveillance 3520 IP Camera Installation Guide |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
| ||
