Chapter 2 Camera Installation
IP Camera Installation
Step 5 Secure the IP camera to the conduit base with two included screws.
Step 6 Feed a shielded twisted pair (STP) Category 5 or higher network cable through the conduit base and connect to the LAN port on the back of the camera. Connect the other end of the network cable to a 10/100/BaseT router or switch.
If your network provides PoE, the IP camera powers on.
Step 7 (Optional) Feed the following cables through the conduit base and connect to the GPIO terminal block on the IP camera:
•External power cable to the GPIO terminal block if PoE is not available.
•(Optional) I/O cables for external input or out put devices, such as sensors or alarms, to the GPIO terminal block
The pin locations and descriptions are as follows:
1 2 3 4 5 6 7 8
Pin | Description |
|
|
1 | 12 VDC- |
|
|
2 | 12 VDC+ |
|
|
3 | 24 VAC |
|
|
4 | 24 VAC |
|
|
5 | DI- |
|
|
6 | DI+ |
|
|
7 | DO- |
|
|
8 | DO+ |
|
|
Step 8 (Optional) Use a mini cable with BNC connector to temporarily attach an NTSC or PAL compliant analog video display device to the analog video out port on the IP camera.
| Cisco Video Surveillance 3520 IP Camera Installation Guide |
