Cisco Systems OL-5512-01 manual Option, Description, Scramble Configuration, Framing

Chapter 6 Adding Cisco IOS Routers to Cisco WAPMS

Adding Routers in Network Configuration

Figure 6-3 ASE Configuration Window

Step 8 In the ASE Configuration window for ATM routers, click ATM to verify the WAN link layer parameters for the router (this option is not available for Frame Relay).

The ATM Link Layer Configuration window appears, as shown in Figure 6-4.

Figure 6-4 ATM Link Layer Configuration Window

For ATM read-only settings, see Table 6-1.

Table 6-1 ATM Link Layer Settings for Cisco Routers

Option	Description
Scramble Configuration	Indicates whether payload data is scrambled at transmission and
	unscrambled when received. Displayed values are Enabled or
	Disabled. This parameter is set at the device during installation.
Framing	Method of cell synchronization. Displayed values are HEC (header
	error control) or PLCP (physical layer convergence protocol). This
	parameter is set at the device during installation.

Step 9 Once you have verified the ATM link layer settings, click Close.

Step 10 Click Close in the ASE Configuration window.

Step 11 Click OK in the Add/Edit an Access Line window to apply the settings.

Cisco WAN Access Performance Management System User Guide, 2.1

6-4 OL-5512-01