Chapter 6: Configuration
=
If you select the scheduler mode with weighted, then the screen will change as shown in this figure.
Figure 6-70. QoS Egress Port Scheduler and Shapers Port 1 screen.
Parameter Description
Port: The logical port for the settings contained in the same row. Click on the port number to configure the shapers.
Shapers (Qn): Show “disabled” or actual queue shaper rate, for example, “800 Mbps.”
Shapers (Port): Show “disabled” or actual port shaper rate, for example, “800 Mbps.”
Scheduler Mode: Control whether the scheduler mode is “Strict Priority” or “Weighted” on this switch port.
Queue Shaper Enable: Control whether the queue shaper is enabled for this queue on this switch port.
Queue Shaper Rate: Control the rate for the queue shaper. The default value is 500. This value is restricted to 100–1,000,000 when the unit is “kbps,” and it is restricted to 1–10,000 when the unit is “Mbps.”
Queue Shaper Unit: Control the unit of measure for the queue shaper rate as “kbps” or “Mbps.” The default value is “kbps.”
Queue Shaper Excess: Control whether the queue is allowed to use excess bandwidth.
Queue Scheduler Weight: Control the weight for this queue. The default value is “17.” This value is restricted to 1–100. This parameter is only shown if “Scheduler Mode” is set to “Weighted.”
LGB5028A User‘s Manual | Page 143 | |
|
|
