Chapter 6: Configuration
Snooping Enabled: Enable the
MLD Querier: A router sends MLD Query messages onto a particular link. This router is called the querier. Enable the MLD querier in the VLAN.
Compatibility: Compatibility is maintained by hosts and routers taking appropriate actions depending on the versions of MLD operating on hosts and routers within a network. Select from
Rv: Show Robustness Variable. The Robustness Variable allows tuning for the expected packet loss on a network. The allowed range is 1 to 255; the default value is 2.
QI: Query interval. The query interval is the interval between general queries sent by the querier. The allowed range is 1 to 31744 seconds; the default query interval is 125 seconds.
QRI: Query Response Interval. The maximum response delay used to calculate the maximum response code inserted into the periodic general queries. The allowed range is 0 to 31744 in tenths of seconds; the default query response interval is 100 in tenths of seconds (10 seconds).
LLQI (LMQI for IGMP): Show Last Listener Query Interval. The Last Listener Query Interval is the maximum response delay used to calculate the maximum response code inserted into multicast
It is also the maximum response delay used to calculate the maximum response code inserted into multicast address and source- specific query messages. The allowed range is 0 to 31744 in tenths of seconds. The default last listener query interval is 10 in tenths of seconds (1 second).
URI: Show the Unsolicited Report Interval. The Unsolicited Report Interval is the time between repetitions of a node's initial report of interest in a multicast address. The allowed range is 0 to 31744 seconds; the default unsolicited report interval is 1 second.
Upper right icon (Refresh, <<, >> ): Click “Refresh” to refresh the IGMP Group Status by manual; use “<<” and “>>” to go to the next/previous page or entry.
Buttons:
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
6.6.3 Port Group Filtering
The section describes how to set the Port Group Filtering in the MLD Snooping function. Via the UI, you can add new filtering groups and safety policies.
Web Interface
To configure the MLD Snooping Port Group Configuration in the Web interface:
1.Click “Configuration,” “MLD Snooping,” “Port Group Filtering Configuration.”
2.Click “Add new Filtering Group.”
3.Specify the Filtering Groups with entries per page.
4.Click the “Save” button to save the setting.
5.To cancel the setting, click the “Reset” button. It will revert to previously saved values.
Page 86 | LGB5028A User‘s Manual | |
|
|
