Chapter 7: Security
7.2.2 Static Table
The section describes how to configure the switch’s static ARP inspection table parameters. Use this table to manage the ARP entries.
Web Interface
To configure a static ARP inspection table configuration in the Web interface:
1.Click “Add new entry.”
2.Specify the port, VLAN ID, IP address, and MAC address in the entry.
3.Click “Save.”
Figure 7-5. The Static ARP Inspection Table screen.
Parameter Description
Delete: Check to delete the entry. It will be deleted during the next save.
Port: The logical port for the settings.
VLAN ID: The VLAN ID for the settings.
MAC Address: Allowed Source MAC address in ARP request packets.
IP Address: Allowed Source IP address in ARP request packets.
Adding new entry: Click to add a new entry to the Static ARP Inspection table. Specify the Port, VLAN ID, MAC address, and IP address for the new entry. Click “Save.”
Buttons:
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
Page 176 | LGB5028A User‘s Manual | |
|
|
