Chapter 5: System Configuration
Figure 5-8. The IP Configuration screen.
Parameter Description
DHCP Client: Enable the DHCP client by checking this box. If DHCP fails and the configured IP address is zero, DHCP will retry. If DHCP fails and the configured IP address is non-zero, DHCP will stop and the configured IP settings will be used. The DHCP client will use the configured System Name as hostname to provide DNS lookup.
IP Address: Provide the IP address of this switch in dotted decimal notation.
IP Mask: Provide the IP mask of this switch dotted decimal notation.
IP Router: Provide the IP address of the router in dotted decimal notation.
VLAN ID: Provide the managed VLAN ID. The allowed range is 1 to 4095.
DNS Server: Provide the IP address of the DNS server in dotted decimal notation.
DNS Proxy: When DNS proxy is enabled, the Device Under Test (DUT) will relay DNS requests to the current configured DNS server on DUT, and reply as a DNS resolver to the client device on the network.
5.4.2 IPv6
This section describes how to configure the
Configure the
The “Configured” column is used to view or change the IPv6 configuration.
The “Current” column is used to show the active IPv6 configuration.
Web Interface
To configure Management IPv6 of the switch in the Web interface:
1.Click “System,” “IPv6 Configuration.”
2.Specify the IPv6 settings, and enable Auto Configuration service if required.
3.Click “Save.”
LGB5028A User‘s Manual | Page 27 | |
|
|
