Chapter 6: Configuration
Web Interface
To configure Access Control List in the Web interface:
1.Click “Configuration,” “ACE,” then “Configuration.”
2.Click the button to add a new ACE, or use the other ACE modification buttons to specify the editing action (that is, edit, delete, or move the relative position of entry in the list).
3.Specify the parameter of the ACE.
4.Click on the “Save” button to save the setting.
5.If you want to cancel the setting, click on the “Reset” button. The setting will revert to previously saved values.
NOTE: When editing an entry on the ACL Configuration page, the Items displayed depend on various selections, such as Frame Type and IP Protocol Type.
6.Specify the relevant criteria to match for this rule, and set the actions to take when a rule is matched (such as Rate Limiter, Port Copy, Logging, and Shutdown).
Figure 6-9. The Access Control List Configuration screen.
Parameter Description
Ingress Port: Indicate the ingress port of the ACE. Possible values are:
Any: The ACE will match any ingress port.
Policy: The ACE will match ingress ports with a specific policy.
Port: The ACE will match a specific ingress port.
Page 52 | LGB5028A User‘s Manual | |
|
|
