Chapter 6: Configuration
Parameter Description
MAC Table Columns
Type: Indicates whether the entry is a static or a dynamic entry.
VLAN: The VLAN ID of the entry.
MAC Address: The MAC address of the entry.
Port Members: The ports that are members of the entry.
Upper right icon (Refresh, Clear, <<, >>): Click “Refresh” to refresh the MAC address entries by manual, or press “Clear” to clean up the MAC table. Press “<<” or “>>” to go to the next/previous page of the table.
NOTE:
6.10 VLAN
Assign a specific VLAN for management. The management VLAN is used to establish an IP connection to the switch from a workstation connected to a port in the VLAN. This connection supports a VSM, SNMP, and Telnet session. By default, the active management VLAN is VLAN 1, but you can designate any VLAN as the management VLAN using the management VLAN swindow. Only one management VLAN can be active at a time.
When you specify a new management VLAN, your HTTP connection to the old management VLAN is lost. For this reason, you should have a connection between your management station and a port in the new management VLAN or connect to the new management VLAN through a
6.10.1 VLAN Membership
You can monitor and modify the VLAN membership configuration for the selected switch unit here. Up to 4096 VLANs are supported. This page enables you to add and delete VLANs as well as add and delete port members of each VLAN.
Web Interface
To configure VLAN membership in the Web interface:
1.Click “VLAN Membership Configuration.”
2.Specify Management VLAN ID.
3.Click “Save.”
Page 112 | LGB5028A User‘s Manual | |
|
|
