Chapter 8: Maintenance
Figure 8-3. The Software Image screen.
Parameter Description
Activate Alternate Image: Click to use the alternate image. This button may be disabled depending on system state.
Cancel: Cancel activating the backup image. Navigates away from this page.
Image: The flash index name of the firmware image. The name of primary (preferred) image is “managed,” the alternate image is named “managed.bk.”
Version: The version of the firmware image.
Date: The date when the firmware was produced.
NOTES:
1.If the active firmware image is the alternate image, only the "Active Image" table is shown. In this case, the Activate Alternate Image button is also disabled.
2.If the alternate image is active (because of a corruption of the primary image or by manual intervention), uploading a new firm- ware image to the device will automatically use the primary image slot and activate this.
3.The firmware version and date information may be empty for older firmware releases. This does not constitute an error.
8.3 Save/Restore
This section describes how to save and restore the switch configuration including reset to Factory Defaults, Save Start, Save Users, and Restore Users.
8.3.1 Factory Defaults
This section describes how to reset the switch configuration to Factory Defaults. Any configuration files or scripts will recover to factory default values.
LGB5028A User‘s Manual | Page 209 | |
|
|
