Chapter 6: Configuration

6.8.2 LLDP Neighbors

This page provides a status overview for all LLDP neighbors. The displayed table contains a row for each port on which an LLDP neighbor is detected. The columns hold the following information:

Web Interface

To show LLDP neighbors:

1.Click “LLDP Neighbors.”

2.Click “Refresh” for manual update Web screen.

3.Click “Auto-refresh” for auto-update Web screen.

Figure 6-42. The LLDP Neighbor Information screen.

NOTE: If your network without any device supports LLDP then the table will show “No LLDP neighbor information found.” Parameter Description

Local Port: The port on which the LLDP frame was received.

Chassis ID: The Chassis ID is the identification of the neighbor’s LLDP frames.

Remote Port ID: The Remote Port ID is the identification of the neighbor port.

System Name: System Name is the name advertised by the neighbor unit.

Port Description: Port Description is the port description advertised by the neighbor unit.

System Capabilities:

System Capabilities describes the neighbor unit’s capabilities. The possible capabilities are:

1.Other

2.Repeater

3.Bridge

4.WLAN Access Point

5.Router

6.Telephone

7.DOCSIS cable device

8.Station only

9.Reserved

When a capability is enabled, the capability is followed by (+). If the capability is disabled, the capability is followed by (-). System Description: System Description is the port description advertised by the neighbor unit.

LGB5028A User‘s Manual

724-746-5500 blackbox.com

Page 97

 

 

Page 97
Image 97
Black Box LGB5028A, LGB5052A, 24 + or 48 + 4-Port Gigabit Managed Switch with SFP+ 10G user manual Lldp Neighbors