Chapter 7: Security
7. Security
This chapter describes all the switch security configuration tasks used to enhance the security of local network, including “IP Source Guard,” “ARP Inspection,” “DHCP Snooping,” “AAA,” etc..
7.1 IP Source Guard
The section describes how to configure the switch’s IP Source Guard detail parameters. Configure the IP Source Guard to enable or disable ports on the switch.
7.1.1 Configuration
This section describes how to configure IP Source Guard setting including:
Mode (Enabled and Disabled)
Maximum Dynamic Clients (0, 1, 2, Unlimited)
Web Interface
To configure an IP Source Guard Configuration in the Web interface:
1.Select “Enabled” in the IP Source Guard Configuration mode.
2.Select “Enabled” for the specific port in port mode configuration.
3.Select maximum dynamic clients (0, 1, 2, unlimited) for the specific port in port mode configuration.
4.Click “Save.”
Figure 7-1. The IP Source Guard Configuration screen.
Page 172 | LGB5028A User‘s Manual | |
|
|
