Chapter 5: System Configuration
Figure 5-10. The System Log Configuration screen.
Parameter Description
Server Mode: Indicates the server mode operation. When the mode operation is enabled, the syslog message will be sent out to the syslog server. The syslog protocol is based on UDP communication and received on UDP Port 514. The syslog server will not send acknowledgments back to the sender since UDP is a connectionless protocol and it does not provide acknowledgments. The syslog packet will always be sent out even if the syslog server does not exist. Possible modes are:
Enabled: Enable server mode operation.
Disabled: Disable server mode operation.
Server Address 1 and 2: Indicates the IPv4 host addresses of syslog server 1 and server 2 (for redundancy). If the switch provides DNS feature, it also can be a host name.
Syslog Level: Indicate what kind of message will be sent to syslog server. Possible modes are:
Info: Send information, warnings, and errors.
Warning: Send warnings, and errors.
Error: Send errors.
5.5.2 Log
This section describes the switch’s system log information.
Web Interface
To display the log information in the Web interface:
1.Click “Syslog,” “Log.”
2.Display the log information.
LGB5028A User‘s Manual | Page 29 | |
|
|
