![](/images/new-backgrounds/1172628/172628287x1.webp)
Chapter 6: Configuration
Queue Scheduler Percent: Show the weight in percent for this queue. This parameter is only shown if “Scheduler Mode” is set to “Weighted.”
Port Shaper Enable: Control whether the port shaper is enabled for this switch port.
Port Shaper Rate: Control the rate for the port shaper. The default value is 500. This value is restricted to
Port Shaper Unit: Control the unit of measure for the port shaper rate as “kbps” or “Mbps.” The default value is “kbps.”
Buttons:
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
6.14.5 Port Tag Remarking
This section provides an overview of QoS egress port tag remarking for all switch ports. The ports belong to the currently selected unit, as reflected by the page header.
Web Interface
To display the QoS Port Tag Remarking in the Web interface:
1. Click “Configuration,” “QoS,” “Port Tag Remarking.”
Click the port index to set the QoS port tag remarking.
Figure 6-71. The Port Tag Remarking screen.
Parameter Description
Port: The logical port for the settings contained in the same row. Click on the port number to configure tag remarking.
Page 144 | LGB5028A User‘s Manual | |
|
|