Chapter 6: Configuration
Action: Configure the action performed when a loop is detected on a port. Valid values are “Shutdown Port,” “Shutdown Port and Log,” or “Log Only.”
TX Mode: Control whether the port is actively generating loop protection PDUs, or whether it is just passively looking for looped PDUs.
Buttons:
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
6.16.2 Status
This page displays the loop protection port status for the switch ports.
Web Interface
To configure the loop protection parameters in the Web interface:
1.Click “Configuration,” “Loop Protection,” “Status.”
2.Check the box next to
Figure 6-84. The Loop Protection Status screen.
Parameter Description
Port: The switch port number of the logical port.
Action: The currently configured port action.
Transmit: The currently configured port transmit mode.
Loops: The number of loops detected on this port.
Status: The current loop protection status of the port.
Loop: Show which loop is currently detected on the port.
Time of Last Loop: The time since the last loop event was detected.
Page 164 | LGB5028A User‘s Manual | |
|
|
