1-41
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-8241-02
Chapter1 Configuring Interfaces and Circuits
Configuring RIP for an IP Interface
Configuring RIP Packet Logging
By default, CSS of logging received or transmitted RIP packets on the interface
is disabled. Use the rip log command to enable the CSS to log received or
transmitted RIP packets on the interface.
The options for this command are as follows:
•rip log rx - CSS logs RIP packets received on the interface
•rip log tx - CSS logs RIP packets transmitted on the interface
For example:
(config-circuit-ip[VLAN7-192.168.1.58])# rip log rx
Showing RIP Configurations for IP Addresses
Use the show rip command to show a RIP configuration for one IP address or all
IP addresses configured in the CSS. The options for this command are as follows:
•show rip - Displays RIP configurations for all interfaces (including the
logging of RIP packets)
•show rip ip_address - Displays a single RIP interface entry
•show rip globals - Displays RIP global statistics
•show rip statistics - Displays RIP interface statistics for all interfaces
•show rip statistics ip_address - Displays RIP interface statistics for a
specific interface