Cisco Systems OL-8241-02 Configuring the CSS IP Interface as an OSPF Interface

3-23
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-8241-02
Chapter3 Configuring Open Shortest Path First
Configuring OSPF on a CSS IP Interface
Configuring the CSS IP Interface as an OSPF Interface
An OSPF interface is an IP interface that you configure to send and receive OSPF
traffic. To configure the CSS IP interface as an OSPF interface, use the ospf
command.
Note You must enter the ospf command before the ospf enable command can take
effect.
To configure the CSS IP interface as an OSPF interface:
1. Access the circuit configuration mode for the preconfigured circuit on which
you want to create the IP interface. For example, if circuit VLAN6 already
exists, enter:
(config)# circuit VLAN6
(config-circuit[VLAN6])#
Note Refer to Chapter 1, Configuring Interfaces and Circuits for
information on how to configure the CSS interfaces and circuits, and
bridge interfaces to VLANs.
2. Create the IP interface to the circuit. To create an IP address of 3.1.2.2, enter:
(config-circuit[VLAN6])# ip address 3.1.2.2/24
Create ip interface <3.1.2.2>, [y/n]:y
3. Configure this circuit as an OSPF circuit. Enter:
(config-circuit-ip[VLAN6-3.1.2.2])# ospf