Cisco Systems manual Using the setup Command, Before Starting Your Cisco VG224, C H A P T E R

C H A P T E R 2

Using the setup Command

This chapter describes how to use the setup command facility to configure your Cisco VG224. The setup command facility prompts you to enter information needed to start a router functioning quickly. The facility steps you through a basic configuration, including LAN and WAN interfaces.

This chapter presents the following major topics:

•Before Starting Your Cisco VG224, page 2-1

•Using the setup Command, page 2-2

•Configuring Global Parameters, page 2-2

•Configuring Controller and Interface Parameters, page 2-5

•Completing the Configuration, page 2-6

•Where to Go Next, page 2-7

If you prefer to configure the router manually or you wish to configure a module or interface that is not included in the setup command facility, proceed to “Chapter 3, “Configuring with the Command-Line Interface,” for step-by-step instructions.

Before Starting Your Cisco VG224

Before you power on your Cisco VG224 and begin to use the setup command facility, make sure to follow these steps:

Step 1 Set up the hardware as described in the installation documents for your Cisco VG224.

Step 2 Configure your PC terminal emulation program for 9600 baud, 8 data bits, no parity, and 1 stop bit.

Step 3 Determine which network protocols you are supporting.

Step 4 Determine the addressing plan for each network protocol.

Cisco VG224 Voice Gateway Software Configuration Guide

OL-5005-01 2-1