Chapter 2 Using the setup Command
Configuring Global Parameters
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use
Default settings are in square brackets '[]'.
Step 2 When the following message appears, enter yes to begin the initial configuration dialog:
Would you like to enter the initial configuration dialog? [yes/no]:
Note If you answer no to this message, you are prompted to terminate AutoInstall. AutoInstall is a procedure that configures a new Cisco VG224 based on the configuration of an existing Cisco VG224.
If you terminate AutoInstall, you enter the Cisco IOS software CLI.
Note The number of interfaces shown depends on the Cisco VG224.
Step 3 When the following message appears, press Return to see the current interface summary:
First, would you like to see the current interface summary? [yes]:
Any interface listed with OK? value “NO” does not have a valid configuration
Interface | OK? | Method | Status | Protocol | |
FastEthernet0/0 unassigned | NO | unset | up | down | |
Step 4 Enter a host name for the Cisco VG224:
Configuring global parameters:
Enter host name [Router]: VG224
The enable secret is a password used to protect access to privileged EXEC and configuration modes. This password, after entered, becomes encrypted in the configuration.
Step 5 Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the configuration.
Enter enable secret: xxxx
The enable password is used when you do not specify an enable secret password, with some older software versions, and some boot images.
Step 6 Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure) and can be seen when viewing the configuration.
Enter enable password: guessme
The virtual terminal password is used to protect access to the router over a network interface.
Step 7 Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the console port:
Enter virtual terminal password: guessagain
Step 8 Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [yes]:
Cisco VG224 Voice Gateway Software Configuration Guide
| ||
|
