Cisco Systems 7600 Configuring the Gigabit Ethernet Interfaces, Configuring the POS Interfaces

Chapter 2 Basic MSFC Software Configuration

Configuring the MSFC2

These sections describe how to configure the Layer 3 interfaces on the modules installed in the Cisco 7600 OSR:

•Configuring the Gigabit Ethernet Interfaces, page 2-10

•Configuring the POS Interfaces, page 2-10

•Configuring the ATM Interfaces, page 2-11

•Verifying and Saving the Layer 3 Interface Configuration, page 2-11

Configuring the Gigabit Ethernet Interfaces

The Layer 3 Gigabit Ethernet module WAN interfaces enable connections to external Gigabit Ethernet networks.

This example shows a configuration dialog for a four-port GE WAN Gigabit Interface Converter (GBIC) module. You should respond to the queries according to your configuration requirements. Use your IP address and subnet mask in responding to the setup prompts.

Configuring interface GigabitEthernet3/0:

Is this interface in use?: yes

Configure IP on this interface?: yes

Configure IP unnumbered on this interface?: no

IP address for this interface: 2.2.1.1

Number of bits in subnet field: 0

Class A network is 2.0.0.0, 0 subnet bits; mask is 255.0.0.0

Configure CLNS on this interface?: yes

For complete Gigabit Ethernet interface configuration information, refer to the Cisco 7600 Optical Services Router Software Configuration Guide.

Configuring the POS Interfaces

The POS module interfaces enable connections to external OC-3/STM-1 or

OC-12/STM-4 networks.

This example shows a configuration dialog for an OC-3c POS module. You should respond to the queries according to your configuration requirements. Use your IP address and subnet mask when responding to the setup prompts.

Configuring interface POS4/0:

Is this interface in use?: yes

Configure IP on this interface?: yes

Configure IP unnumbered on this interface?: no

	Cisco 7600 Optical Services Router Quick Software Configuration Guide
2-10	78-12799-01