Cisco Systems 7600 manual This display shows that no interfaces have been configured

Chapter 2 Basic MSFC Software Configuration

Configuring the MSFC2

This display shows that no interfaces have been configured:

Interface	IP-Address	OK? Method	Status	Protocol
Ethernet0	unassigned	YES unset	administratively down down
POS3/0	unassigned	YES unset	administratively down down
POS3/1	unassigned	YES unset	administratively down down
POS3/2	unassigned	YES unset	administratively down down
POS3/3	unassigned	YES unset	administratively down down
ATM4/0	unassigned	YES unset	administratively down down

The following sample display results from a yes response to the current interface summary query that is entered while you use the setup command.

This display shows that some interfaces have already been configured:

Interface	IP-Address	OK? Method	Status	Protocol
Ethernet0	3.3.1.1	YES NVRAM	up	up
POS3/0	2.1.1.1	YES NVRAM	up	up
POS3/1	2.1.1.2	YES NVRAM	up	up
POS3/2	2.1.1.3	YES NVRAM	up	up
POS3/3	2.1.1.4	YES NVRAM	up	up
ATM4/0	1.1.1.2	YES NVRAM	up	up

Step 3 Select the protocols that you intend to support for your network interfaces.

For IP-only installations, you can accept the default values for most of the questions.

A typical minimum configuration procedure using IP follows and continues through Step 8:

Configuring global parameters:

Enter host name [Router]: Router

Step 4 Enter the enable secret password when prompted to do so:

The enable secret is a one-way cryptographic secret used instead of the enable password when it exists.

Enter enable secret [<Use current secret>]: barney

For future use, make a note of this password.

	Cisco 7600 Optical Services Router Quick Software Configuration Guide
2-6	78-12799-01