Cisco Systems 7600 manual Reboot the router and enable it using the recovered password

Chapter 2 Basic MSFC Software Configuration

Performing Other Configuration Tasks

After the interface configuration information is displayed, the user EXEC mode prompt appears:

Router>

Step 10 Enter the enable command at the user EXEC mode prompt to enter the privileged EXEC mode:

Router> enable

Router#

Step 11 Enter the show start-up config command at the privileged EXEC mode prompt to display the enable password in the configuration file:

Router# show start-up config

.

.

.

Step 12 Enter the configure terminal command at the privileged EXEC mode prompt to enter the global configuration mode:

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#

Step 13 Change the software configuration register setting back to its original value. Alternatively, change this value to 0x0102 (the factory default) by entering the config-registervalue command:

Router(config)# config-register 0xvalue

Router(config)#

Step 14 Exit the global configuration mode by pressing Ctrl-Zor entering the end command.

Router(config)# end

Router#

Step 15 Reboot the router and enable it using the recovered password.

	Cisco 7600 Optical Services Router Quick Software Configuration Guide
2-28	78-12799-01