Chapter 2 Basic MSFC Software Configuration
Configuring the MSFC2
Answer yes if you want to save the running configuration file to NVRAM and display the following additional output:
Use this configuration? [yes/no]: yes [OK]
Use the enabled mode 'configure' command to modify this configuration. Press RETURN to get started!
After you press Return, the system reverts to the user EXEC prompt:
Router>
Answer no to the configuration query to return to the privileged EXEC mode prompt (Router#). You must reenter the setup command and enter the appropriate modules configuration information.
When you complete this procedure, you have manually configured the global system parameters and the network interface parameters using the setup facility or the setup command. Your Gigabit Ethernet, POS, and ATM interfaces are now available for limited use.
If you want to modify the currently saved configuration information (after you complete the preceding procedure), enter the setup command at the privileged EXEC mode prompt (Router#) at any time.
To perform more complex configuration tasks, you can enter the configure command at the privileged EXEC mode prompt (Router#), which establishes the global configuration mode [Router(config)#]. This mode is described in the “Using the Global Configuration Mode” section on page
Checking the IOS Software Version Number and the Installed Interfaces
To determine the current Cisco IOS software version running on the MSFC2 in the Cisco 7600 OSR, enter the show version command at the user EXEC prompt (Router>).
This command displays the Cisco IOS version number and other information, including the hardware installed in the system, the names and sources of system image files, and the contents of the software configuration register.
| Cisco 7600 Optical Services Router Quick Software Configuration Guide |
|
