Cisco Systems VG224 manual Saving Configuration Changes, Where to Go Next, Command, Purpose

Chapter 3 Configuring with the Command-Line Interface

Saving Configuration Changes

	Command	Purpose
Step 7
	Router(config-if)# exit	Exits back to global configuration mode.
		Repeat Step 4 through Step 6 if your Cisco VG224
		has more than one interface that you need to
		configure.
Step 8
	Router(config-if)# Ctrl-z	When you finish configuring interfaces, returns to
	Router#	enable mode.

Saving Configuration Changes

To prevent the loss of the Cisco VG224 configuration, save it to NVRAM:

Step 1

Step 2

Step 3

Command	Purpose
Router> enable	Enters enable mode. Enter the password.
Password: password	You have entered enable mode when the prompt
Router#	changes to Router#.
Router# copy running-config startup-config	Saves the configuration changes to NVRAM so
	that they are not lost during resets, power cycles,
	or power outages.
Router(config-if)# Ctrl-z	Returns to enable mode.
Router#
%SYS-5-CONFIG_I: Configured from console by	This message is normal and does not indicate an
	error.
console

Where to Go Next

At this point you can proceed to the following:

•The Cisco IOS software configuration guide and command reference publications for more advanced configuration topics. These publications are available on Cisco.com or on the Documentation CD-ROM, or you can order printed copies.

•Cisco System Error Messages, Release 12.3(4)T, and Cisco Debug Command Reference, Release 12.3(4)T provide troubleshooting information. For these and other documents, see Obtaining Documentation, page x.

Cisco VG224 Voice Gateway Software Configuration Guide

OL-5005-01 3-5