Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WAN Interface Card
How to Configure the Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WIC
13
Cisco IOS Release 12.3(14)T
.......................................................................................
.................................
TTY1: WIC-AM: Modem firmware download finished...
TTY34: WIC-AM: Modem firmware download finished.......
TTY33: WIC-AM: Modem firmware download finished...
Finished upgrading modem firmware.
Verifying the Modem Firmware Upgrade
Use these steps to verify that the firmware was upgraded in theCisco WIC-1AM-V2 and WIC-2AM-V2
Analog Modem WIC.
SUMMARY STEPS
1. enable
2. show modem
3. exit
DETAILED STEPS
Examples
The show modem [slot/port | group number] command shows the state of the specified asynchronous
interface.
Example:
Router#show modem 0/0 | inc firmware
WIC-AM firmware ACF3_V1.922F-V90_4M_FSH
Command or Action Purpose
Step1 enable
Example:
Router> enable
Enables privileged EXEC mode.
•Enter your password if prompted.
Step2 show modem [slot/port | group number]
Example:
Router# show modem 0/0 | inc firmware
Display a high-level performance report for all the modems
or a single modem inside Cisco access servers.
•slot/port— (Optional) Location of a slot and modem
port. The forward slash (/) is required when you are
entering this variable.
•group number— (Optional) Assigns the group to
which a specified modem belongs. The group number
range is from 1 to 200.
Step3 exit
Example:
Router# exit
Exits privileged EXEC mode.