Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WAN Interface Card
How to Configure the Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WIC
14
Cisco IOS Release 12.3(14)T
The show modem [slot/port | group number] command shows various performance statistics for a
modem or group of modems.
Example:
Router# show modem 0/3/0
Mdm Typ Status Tx/Rx G Duration TX RX RTS CTS DSR DCD DTR
0/3/0 UnKn Idle / 0 00:00:00 - - x x x x
Modem 0/3/0 [line 50], Async0/3/0, TTY50
WIC-AM firmware ACF3_V1.922F-V90_4M_FSH
Modem config: Incoming and Outgoing
Protocol: UnKn, Compression: UnKn
Last clearing of "show modem" counters: never
0 incoming complete
0 incoming failures
0 outgoing complete
0 outgoing failure
Troubleshooting the Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WIC
To troubleshoot the Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WIC, use the following
commands, starting in privilege EXEC configuration mode.
•Debugging Call Connect, page14
•Debugging Call Disconnect, page16

Debugging Call Connect

Complete the following steps to debug call connect on the Cisco WIC-1AM-V2 and WIC-2AM-V2
Analog Modem WIC.
SUMMARY STEPS
1. enable
2. debug modem
3. debug dialer
4. ping system-address
5. exit