Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WAN Interface Card
How to Configure the Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WIC
16
Cisco IOS Release 12.3(14)T
Feb 10 20:34:20: As1 DDR: Dialer statechange to up
Feb 10 20:34:20: As1 DDR: Dialer call has been placed
Feb 10 20:34:20: Modem 0/0: PPP escape map: Tx map = FFFFFFFF, Rx map = 0
Feb 10 20:34:20: Modem 0/0: PPP escape map: Tx map = A0000, Rx map = 0
Feb 10 20:34:21: As1 DDR: dialer protocol up
Feb 10 20:34:21: %LINEPROTO-5-UPDOWN: Line protocol on Interface Async1, changed state to
up
Debugging Call Disconnect
Complete these steps to debug call disconnect on the Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog
Modem WIC.
SUMMARY STEPS
1. enable
2. debug modem
3. debug dialer
4. clear modem
5. exit
DETAILED STEPS
Command or Action Purpose
Step1 enable
Example:
Router> enable
Enables privileged EXEC mode.
•Enter your password if prompted.
Step2 debug modem
Example:
Router# debug modem
Aids in troubleshooting the modem WIC.
•Use the no form of the command to stop the debugging
process.
Step3 debug dialer events
Example:
Router# debug dialer events
Aids in troubleshooting the modem WIC.
•Use the no form of the command to stop the debugging
process.
Step4 clear modem slot/port
Example:
Router# clear modem 0/0
Reset the hardware of the modem WIC.
•slot/port - Slot and modem port number. (Include the
slash mark when entering this variable, for example:
1/1.)
Step5 exit
Example:
Router# exit
Exits privileged EXEC mode.