3-4
Cisco 170 Series Hardware Installation Guide
OL-28365-01
Chapter
Step 2 Remove the square hole insert from the front of the rail.
Step 3 Align the threaded hole bracket (see D in Figure 3-1) to the front of the rail over the hooks. Secure it
with the threaded hole standoff (see E in Figure 3-1) using a flat-head screwdriver.
Step 4 No additional hardware is necessary for the rear adapter.
Step 5 Repeat the previous steps page for the other slide rail.
Step 6 Proceed to the “Attaching the Outer Slide Rail to Threaded Hole Racks” section on page 3-5.
Attaching the Outer Slide Rail to Round and Square Hole Racks
Step 1 Align the front of one of the outer slide rails with the rack upright, push it forward, and click it into place.
Align the rear of the outer slide rail with the rack upright, pull the release tab, push the slide rail toward
the rack, release the tab, and click it into place.
Note For racks shorter than 24 inches in depth, remove the rear bracket with a Phillips head screwdriver, pull
the release tab, and adjust the slide rail to the appropriate length for the rack.
330884
330882
330878
330876