Cissell CSBBYMV Receiving Inspection, Moving and Locating Press, Foundation Requirements, Uncrating, To avoid possible serious injury:

Receiving Inspection

The press is shipped assembled and enclosed in a plastic cover and crate. Upon delivery, inspect crate and contents for shipping damage. If crate or cover is damaged, or signs of possible damage are evident, have carrier note the condition on the shipping papers before shipping receipt is signed, or advise carrier of condition when discovered.

Remove protective cover and check items received against items listed on packing list. If any item is damaged or missing, a written claim should be filed with the carrier as soon as possible.

Moving and Locating Press

IMPORTANT: If a forklift is used to move the press, exercise care that forklift arms are inserted under the frame and do not contact any operating mechanism.

Move press to the installation location while it is still attached to skid. However, press can be removed from skid before moving.

To remove unit from skid, unscrew the four shipping cap screws from the attaching holes and work press from skid.

Press should be located in an area that provides a minimum of 24 inches (61 cm) between press and any structure.

IMPORTANT: The above dimensions are considered minimum working and maintenance dimensions and should be increased if possible.

Foundation Requirements

Install press on a solid, level floor such as concrete.

IMPORTANT: Installation on a wooden floor can cause machine to shift, which will result in misalignment of heads and bucks and damage to both press and garments.

Floor should be capable of supporting 125 pounds (56.7 kilograms) per square foot. Remove all floor covering material (tile, wood, carpeting, etc.) from press mounting area.

Operation

Uncrating

1.Remove wooden crate. Move the press to area of final location and remove wooden skid. Remove all panels.

WARNING

To avoid possible serious injury:

•ALWAYS be careful to AVOID spring- loaded components when working inside press.

•Installation MUST be performed ONLY by qualified service personnel.

W336

2.Install left end guard using attached hardware before opening press heads. Refer to Figure 1 for location if needed.

3.Remove any shipping material on heads and buck.

4.Carefully remove any shipping braces using a hammer or any long-handled striking device, to knock shipping braces away from unit. Avoid using excessive force to remove brace. Excessive force applied to the braces can result in damage to unit and/or alignment of internal parts.

AJ0976