Citizen Systems CLP-7201e user manual Cut Position Adjustments

Appendixes

2 Specifications

zCut Position Adjustments

•The cut position can be specified with the 'fnnn' of the system-level commands. When the tear-off function is turned on, the following initialization value is set in the printer.

Initialization value: fnnn = f735 (73.5 mm)

The values higher or lower will increase or decrease the amount of feed in the tear-off.

•Parameter initialization values

Initialization values of print and feed positions by each operating mode are described below.

If values lower than the minimum values are set, the initialization values will be set instead. (When the virtual distance between the print and feed positions' mode is on.)

80