Clarion AX410 Presetting Stations, Preset Scanning Preset Station Scan, Area Change Function

Presetting Stations

A total of 24 stations can be preset, 6 each for

the FM1, FM2, FM3 and AM bands.

Note:

•When a station is preset, the station previously stored in the memory at that position is cleared.

Presetting stations manually

1)Press the BND button # to select the band at which to store the station.

2)Use the SRCH Left and Right buttons $ to tune in the station to be preset.

3)Press the Preset button ! at which you want to store that station for at least 2 seconds.

Auto store function (Automatic Station Store)

1)Press the BND button # to select the band at which to store the stations.

2)Press the AS button 0 for at least 2 seconds.

Stations with good reception are automatical- ly stored at Preset buttons ! 1 to 6.

*If there are fewer than 6 stations with good recep- tion, the stations previously stored at the remain- ing buttons are not cleared.

Preset Scanning (Preset Station Scan)

When the PS button 0 is pressed, the preset memory numbers flash and the stations are tuned in for 7 seconds each in the order in which they were stored. Press the PS button again to cancel the preset scanning mode.

Instant Station Recall (ISR) Function

This function allows you to recall a specific radio station from any mode. Use it to find stations quickly when you want to hear specific informa- tion (such as traffic announcements) while dri- ving. The ISR station is set to 87.9 MHz upon shipment from the factory.

Setting the ISR station

1)Press the FNC button 4 to select the radio mode.

2)Tune in the station to be set as the ISR sta- tion.

3)Press the ISR button 6 for more than 2 sec- onds to store that station in the memory as the ISR station.

Recalling the ISR station

Press the ISR button 6 from any mode. “ISR” appears on the display and the set station is tuned in. To cancel, press the ISR button again.

Area Change Function

Use this to listen to the radio outside of the United States.

Switchable frequency spacing

This car stereo is initially set to tune in frequen- cy intervals of 10 kHz for AM and 200 kHz for FM, the standard calibrations in the U.S. When using the unit outside the U.S., use the following procedure to switch the frequency steps and fre- quency range:

1)Turn the power on and set the tuner mode.

2)Keep the BND button # pressed and while

pressing the button, press the SRCH Left but- ton $.

3)Release the buttons.

This procedure changes the factory setting to 9 kHz steps for AM and 50 kHz steps for FM, the standard calibrations for countries other than the U.S.

To change the AM/FM setting back to the U.S. standard frequencies:

1)Set the tuner mode.

2)While pressing the BND button #, press the SRCH Right button $.

3)Release the buttons.

Your car stereo will once again be calibrated to receive standard U.S. transmissions.

The chart below lists the frequency specifica- tions for the U.S. and other countries.

		Inital Setting	New Setting
		(U.S. standard)	(outside U.S.)
	Frequency	10 kHz	9 kHz
	spacing
AM
	Frequency	530 to	531 to
	range	1710 kHz	1629 kHz
	Frequency	200 kHz	50 kHz
	spacing
FM
	Frequency	87.9 to	87.5 to
	range	107.9 MHz	108 MHz

AX410 11