8. TROUBLESHOOTING
Problem | Cause | Measure |
|
|
|
Power does not turn on. | Fuse is blown. | Replace with a fuse of the same |
(or no sound is produced.) |
| amperage as the old fuse. |
|
|
|
| Connections are improper. | Read the attached “Installation/Wire |
|
| Connection Guide” once again and |
|
| wire properly. |
|
|
|
Sound quality is poor. | Playback head is dirty. | Use a cleaning tape, etc. to clean the |
|
| head. |
|
|
|
No sound while unit can | Power ANT lead is shorted | Turn the unit off, first. |
be operated. | to the ground. | Remove all connecting wires from the |
|
| power ANT lead, and turn the unit on, |
|
| then |
|
| the power ANT lead. |
|
| When sound is muted again, check |
|
| the unit with a wire connected last. |
|
|
|
This unit is equipped with a number of
| Error Display | Cause | Measure | |
| TAPE ER1 | Tape cannot be played due to defective | Eject the tape then replace it with a new | |
|
| tape such as cut tape. | one. | |
|
|
|
| |
Tape | TAPE ER2 | Tape is caught and cannot be played. | Remove the caught or wound tape. | |
|
|
| ||
TAPE ER4 | Tape mode cannot be detected. | This is a failure of tape mechanism and | ||
|
|
| consult your store of purchase. | |
|
|
|
| |
| TAPE ER8 | Tape is caught and cannot be ejected. | Eliminate the reason for which the tape is | |
|
|
| caught. | |
|
|
|
| |
| CDCH ER2 | A CD inside the CD changer is not | This is a failure of CD changer’s mecha- | |
changer |
| loaded. | nism and consult your store of purchase. | |
|
|
| ||
CDCH ER3 | A CD inside the CD changer cannot be | Replace with a | ||
| played due to scratches, etc. | disc. | ||
CD |
|
|
| |
CDCH ER6 | A CD inside the CD changer cannot be | Eject the disc then reload it properly. | ||
| ||||
|
| played because it is loaded |
| |
|
|
|
|
If a display other than one of the displays above appears, press the reset button. If the problem persists, turn the power off and contact your store of purchase.
AX410 13