Basic Operations
●Adjusting the treble
This adjustment can be performed only when the
“TREB(G)” ↔ “TREB(F)”
∗The factory default setting is “TREB(G)”.
TREB(G) : The factory default setting is “0”. (Adjustment range: +7 to
TREB(F) : The factory default setting is “10K”.
(Adjustment range: 10K/12.5K/15K/17.5K)
●Adjusting the balance
∗The factory default setting is “CENTER” (center). (Adjustment range: RIGHT12 to LEFT12 (right 12 to left 12))
●Adjusting the fader
∗The factory default setting is “CENTER” (center). (Adjustment range: FRONT12 to REAR12 (front 12 to rear 12))
●Adjusting the subwoofer
You can set the low pass filter of subwoofer.
“THROUGH” ↔ “LPF 50” ↔ “LPF 80” ↔ “LPF 120”
∗The factory default setting is “THROUGH”.
●Adjusting the subwoofer output volume
You can adjust the volume output from the unit's subwoofer output terminal.
or decreases the subwoofer volume.
∗The factory default setting is “0”. (Adjustment range: +6 to
∗When the volume level is more than 30, the subwoofer volume adjustment value can not reach +6.
●Adjusting the HPF
“120” ↔ “THROUGH”
∗The factory default setting is “THROUGH”.
∗This is supported only with amplifiers equipped with this function. Output is not supported from RCA cables.
Note:
•During SOUND adjustment mode, if no operation is performed for more than 10 seconds, this mode can be cancelled and return to previous mode.
English
DXZ388RUSB/DXZ389RUSB/DXZ389RGUSB 15