Clarion iDXZ775USB Adjusting the bass, Adjusting the treble, Adjusting the sound restorer

Basic Operations

●Adjusting the bass

2-1. Select “BASS”.

3-1.	Press the [	] button.
3-2.	Push the [P.CH] button upward or
	downward to adjust the gain from –6 to +6
	(The factory default setting is “0”).
3-3.	Press the [	] button to return to the
	previous mode.

●Adjusting the treble

2-1. Select “TREBLE”.

3-1.	Press the [	] button.
3-2.	Push the [P.CH] button upward or
	downward to adjust the gain from –6 to +6
	(The factory default setting is “0”).
3-3.	Press the [	] button to return to the
	previous mode.

●Adjusting the sound restorer

The sound restorer enriches the playback of all types of music files that have undergone any level of data compression.

2-1. Select “S RESTORER”.

3-1. Push the [P.CH] button upward or downward to adjust.

Each time you push the [P.CH] button, the sound restorer changes in the following order:

“OFF” ↔ “1” ↔ “2” ↔ “3”

∗The factory default setting is “OFF”.\

Set this adjustment in accordance with the music source used

OFF: For music sources compressed at high bit rate

1:For music sources compressed for high quality at low bit rate

2:For music sources compressed for standard quality at low bit rate

3:For music sources compressed for low quality at low bit rate

●Adjusting the balance

2-1. Select “BALANCE”.

3-1. Push the [P.CH] button upward to emphasize the sound from the right speaker, push the button downward to emphasize the sound from the left speaker.

∗The factory default setting is “0”. (Adjustment range: L12 to R12)

●Adjusting the fader

“FADER” can be adjusted only when the speaker system is set to “2WAY” or “NORMAL”.

2-1. Select “FADER”.

3-1. Push the [P.CH] button upward to emphasize the sound from the front speaker, push the button downward to emphasize the sound from the rear speaker.

∗The factory default setting is “0”. (Adjustment range: R12 to F12)

●Setting high pass filter

“HPF” can be adjusted only when the speaker system is set to “NORMAL”.

2-1. Select “HPF”.

3-1. Push the [P.CH] button upward or downward to select the setting. Each time you push the [P.CH] button, the setting changes in the following order:

“THRGH” ↔ “50Hz” ↔ “80Hz” ↔ “125Hz”

∗The factory default setting is “THRGH” (through).

●Setting low pass filter

“S-W LPF” can be adjusted only when the speaker system is set to “NORMAL” .

∗If subwoofer function is set to “ST” or “MONO”, “S-W LPF” can be selected.

2-1. Select “S-W LPF”.

3-1. Push the [P.CH] button upward or downward to select the setting.

Each time you push the [P.CH] button, the setting changes in the following order:

“THRGH” ↔ “50Hz” ↔ “80Hz” ↔ “125Hz”

∗The factory default setting is “THRGH” (through).

English

DXZ775USB 15