15. RADIO OPERATIONS

English

Listening to the Radio

1.Touch the [Tuner] button on the Main menu display. The tuner mode screen is displayed.

2.Press the [FM1/2/3/AM] button or touch the [Band] key on remote control to select the radio band. Each time the button is pressed, the radio reception band changes in the following order: FM1->FM2->FM3->AM ->FM1...

7

8

9

10

5

6

4

1

2

3

1.Preset Scan Button 2.Direct Button 3.Preset List Button 4.Frequencies Display 5.Tune Up

6.Tune Down 7.Band Display 8.LOC/DX Display 9.Bluetooth Display 10.System Time

Seek Tuning

1.Press the [FM1/2/3/AM] button to select the radio band (FM or AM).

2.Touch the [] key, and then flick the BIG Frequency up and down to search for next available station.

•When flick the frequency up, the station is searched in the direction of higher frequency.

•When flick the frequency down, the station is searched in the direction of lower frequency.

Step Tuning

Press the [FM1/2/3/AM] button to select the radio band (FM or AM).

2.Touch the [] or [] key in frequency panel to tune up or down by one step.

Recalling a preset station

Press the [FM1/2/3/AM] button to select the desire band (FM or AM) on the tuner.

Touch the [] key, Press the preset station (1 to 6) on preset list.

3.Press the [] key, then press the [] button to auto search and store the stations.

Manual memory

1.Touch the desired Band key to select the band you wish to store.

2.Tune to a station you want to store using the seek tuning, step tuning, or preset tuning.

3.Touch and hold the desired Preset key you want to store for about 3 seconds.

Auto Store

The Auto Store is a function for storing up to 6 stations that are automatically searched in sequentially. If the number of receivable stations cannot reach to 6, the previous stored station remains.

1.Touch the [FM1/2/3/AM] key to select the desired band. (FM or AM)

2.Press the [] key, and then press the [] key to start the Auto Store.

A beep sounds and the stations with good reception are stored automatically to the preset list.

Preset Scan

The Preset Scan receives the stations stored in the preset memory in order. This function is useful when searching for the desired station in memory.

1.Touch the [FM1/2/3/AM] key to select the desired band. (FM or AM)

2.Touch the [] key to start the Preset Scan.

The unit starts scanning each station for 10 seconds sequentially. But the station stored is not a valid station; the scanning time is only 2 seconds.

3.When the desired station is tuned in, touch the

[] key again to stay in that station.

Manual Owner’s

NX501/NZ501 43