Basic Operations
Note:
•Do not move the liquid crystal panel by hand.
●To adjust the slide position
1.Press and hold the [TILT] button and release when a beep is heard.
The liquid crystal panel slides forward or backward. The adjusted slide position is stored in memory.
∗There are 3 adjustable positions available on this panel.
Housing the liquid crystal panel
1. Press the [OPEN/CLOSE] button and the
liquid crystal panel is housed automatically.
Note:
•When leaving this unit unused for a long period of time or leaving your car, be sure to house the liquid crystal panel into the main unit.
Turning the liquid crystal panel horizontal (Air conditioner operation mode)
When the way the liquid crystal panel is mounted hinders the operation of the air conditioner, the position of the panel can be turned horizontal temporarily.
1.Press and hold the [OPEN/CLOSE] button when the liquid crystal panel is upright, and release the button when a beep is heard.
2.The liquid crystal panel turns horizontal.
∗Press the [OPEN/CLOSE] button again when the liquid crystal panel is in the horizontal position, and the panel returns to the original position.
∗Even if the button is not operated for about 10 seconds, the panel returns to the original position with a warning sound.
Turning on and off the monitor
1.Pressing and holding the [BND] button for 1 second or longer turns the monitor off. To return to the monitor on, press the [BND] button once again.
∗When a button is pressed or during security monitoring, the
Car stereo adjustments
1.Set the car stereo’s radio frequency to the modulator frequency. (TB741P/TB742P
only)
∗ The factory set for the modulator frequency is 88.1 MHz. (Refer to the section on selecting the FM modulator frequency on page 15.)
2.Use the car stereo’s volume and tone controls to adjust the volume and tone to the desired levels.
Note:
•Adjust also the BASS (bass)/TREB (treble) and BAL (left/right balance)/FAD (front/back balance) controls to the optimum positions.
English
s’Owner manual
TB741P/TB742P/TB743W 11