■Fixed Mount (TOYOTA, NISSAN and other ISO/DIN equipped vehicles)

English connectionmanual Installationand Wire

This unit is designed for fixed installation in the dashboard.

If the vehicle is equipped with a factory-installed radio, install the main unit with the parts and screws marked (*) (Figure 8).

If the vehicle is not equipped with a factory- installed radio, obtain an installation kit to install the main unit in the following procedure.

1.Remove the screws at both sides of the main unit and slide the springs to the direction of arrow and remove them (Figure 7).

2.Secure the mounting brackets to the chassis as shown in Figure 8. Holes are pre-tapped for TOYOTA and NISSAN vehicles; modification, such as drilling new holes, of the mounting brackets may be required for other models.

3.Wire as shown in Section 7.

4.Secure the unit in the dashboard, and then reassemble the dashboard and the center panel.

2–Screws

Main Unit

2–Springs Screwdriver

Figure 7

Dashboard

4–Hexagonal screws * (M5 ⋅ 8)

Mounting bracket ★

(1 pair for the left and right sides)

★

★

★

Main Unit

★

 

 

★

★

 

 

Pocket

★

★

 

 

 

 

 

Note 2

Center Panel (Note 1)

 

 

*: The parts and screws with this mark

 

 

are used to install radio or included in

 

 

the installation kit.

 

 

★: The parts and screws with this mark

Figure 8

 

are originally attached to the vehicle.

 

Note 1: In some cases, the center panel may

Note 2: If a hook on the installation bracket

require some modification (trimming,

 

interferes with the unit, bend and flatten it

filling, etc.).

 

with a nipper or a similar tool.

24 TB741P/TB742P/TB743W