Clarion TB741P, TB742P, TB743W TV Mode Operations, Auto store function, Watching TV, Seek tuning, Manual tuning, Preset memory function, Manual memory function

TV Mode Operations

CAUTION

For your safety, the driver should not watch the TV or operate the controls while driving. Please note that watching and operating the TV while driving is prohibited by law in some countries. Also, while driving, keep the volume to a level at which external sounds can be heard.

Auto store function

The channels received automatically are automatically stored in the preset channels. The setting procedure for the preset channels is the same for TV1 and TV2.

1.Press the [PS] button for 1 second or longer, the broadcast stations are automatically stored in the memory starting with the one following the station now received.

English

s’Owner manual

Watching TV

1. Press the [BND] button to select TV1, TV2,

1

62

TV1

F.WIDE

VTR1 or VTR2. Each time the [BND] button

is pressed, the setting is switched in the

sequence shown below.

TV1 TV2 VTR1 VTR2

Seek tuning

Keep pressing the [a] or [d] button for about 1 second.

The seek tuning mode is selected. Tuning will stop automatically at a channel where a broadcast is received.

∗When seek tuning has stopped before or after a broadcast channel, press the [a] or [d] button again.

Manual tuning

Press the [a] or [d] button to select the channel.

The channel number appears at the top right of the screen.

∗Each time the [a] or [d] button is pressed, the channel number is incremented or decremented by 1.

∗The channel number remains on the screen for about 5 seconds.

Preset memory function

The number of preset channels which can be stored in the memory is:

•6 stations for TV1	} Total of 12 stations
•6 stations for TV2

Any station can be stored in any preset channel.

2A.STORE

3

4

5

6

Notes:

•The signal conditions are sometimes such that a channel without a station is stored in the memory.

•Some stations may not be stored if their signals are too weak in the reception area.

•When a station could not be stored or a channel without a station has been stored in the memory, refer to the section on the manual memory function which follows, and perform the settings again.

Manual memory function

1.Press the [BND] button to select TV1 or TV2.

2.Press the [MEMO] button, the manual memory screen is displayed.

∗While the channel display at the left of the screen turns red, the manual memory operation is available.

3.Press the [a] ro [d] button to select the channel to be preset.

4.Press the [w] or [z] button to select the preset channel in which the station to be stored.

5.Press the [MEMO] button for 1 second or longer to store the station into the preset memory.

6.To cancel the manual memory mode, press the [MEMO] button again and press the [DISP] button.

Note:

•The memory contents are returned to the default settings when the battery is replaced or the power supply is otherwise suspended.

TB741P/TB742P/TB743W 13