English
6. OPERATIONS
Basic Operations | Note:Be sure to read this chapter referring to the front diagrams of |
chapter “3. CONTROLS” on page 5 (unfold). |
CAUTION
Be sure to lower the volume before switching off the unit power or the ignition key. The unit remembers its last volume setting. If you switch the power off with the volume up, when you switch the power back on, the sudden loud volume may hurt your hearing and damage the unit.
Turning on/off the power
Note:
•Be careful about using this unit for a long time without running the engine. If you drain the car’s battery too far, you may not be able to start the engine and this can reduce the service life of the battery.
1.Press the [SOURCE] knob.
2.The illumination and display on the unit light up. The unit automatically remembers its last operation mode and will automatically switch to display that mode.
3.Press and hold the [SOURCE] knob for 1 sec- ond or longer to turn off the power for the unit.
Note:
•Disk check
This unit will check the discs inside it when you turn on the power for the first time after wiring or when you press the reset button.
•System check
During the initial power up of this unit, it will go through a system check procedure. This proce- dure verifies any devices connected through CeNET. Any additional CeNET devices plugged into the unit after the initial power up will initiate the system check procedure. When the power is turned on, “SYS CHECK” appears in the display if the wire connections were modified. The system check starts automatically within the unit.
Selecting a mode
1.Turn the [SOURCE] knob to change the op- eration mode.
2.Each time you turn the [SOURCE] knob, the operation mode changes in the following or- der:
Radio mode | CD/MP3 mode CD |
changer mode | DVD changer mode |
TV mode AUX mode Radio mode...
∗External equipment not connected through CeNET will not be displayed.
Adjusting the volume
1.Turn the [VOLUME] knob to adjust the vol- ume.
∗The volume level is from 0 (minimum) to 33 (maximum).
Switching the display
●When the power is turned on
1.Each time you press the [DISP] button, the display switches in the following order:
●Radio mode
Main display (frequency) ➜ Title display
➜Clock display ...
●CD/MP3 mode
Folder/Track No. display (MP3/WMA disc only) ➜ Main display (Play time) ➜ Title display ➜ Clock display ...
∗Once selected, the preferred display becomes the display default. When a function adjust- ment such as volume is made, the screen will momentarily switch to that function’s display, then revert back to the preferred display sev- eral seconds after the adjustment.
∗When you have entered a title in a CD/MP3/ WMA, it appears in the display. If you have not entered a title, “NO TITLE” appears in the dis- play. For information on how to enter a title, refer to the subsection “Entering titles” in the section “Common Operations”.
●When the power is turned off
1.Each time you press the [DISP] button, the display switches in the following order: Clock display ➜ Display off ➜ Clock dis- play...
●When the display is turned on
1.Press the [SPE/ANA] button for 1 second or longer to turn off the display.
To turn on the display, press the [SPE/ANA] button again or press the [DISP] button.
∗The following buttons are valid while the dis- play is turned off.
[SOURCE] / [VOLUME] / [ISR] / [LOAD] / [Q]
10 WXZ466MP