Clarion WXZ466MP Display Adjust Mode, Common Operations, Turning the screen saver function, Setting the clock, on or off, Setting the speed of the spectrum analyzer display

		Common Operations
Display Adjust Mode		Turning the screen saver function
Setting the clock		on or off
1.	Press and hold the [DISP] button for 1 sec-	If the screen savers are not desired, they can be
		turned off.
	ond or longer to switch to the display adjust
		If the button operation is performed with the
	mode.
2.	Turn the [SEARCH] knob to select “CLOCK”.	screen saver function on, the operation display
		corresponding to the button operation is shown
3.	Press the [SEARCH] knob.
		for about 30 seconds and the display returns to
4.	Turn the [SEARCH] knob to select the hour
		the screen saver display.
	or the minute.	∗ The factory default setting is “ON”.

English

5.Turn the [A-MODE] knob to set the correct time.

∗ The clock is displayed in 12-hour format.

6.Press the [SEARCH] knob to store the time into memory.

7.Press the [DISP] button to return to the previ- ous mode.

Note:

•You cannot set the clock when it is displayed with only the ignition on. If you drain or remove the car’s battery or take out this unit, the clock is re- set. While setting the clock, if another button or operation is selected, the clock set mode is can- celed.

Setting the sensitivity of the spectrum analyzer display

∗The factory default setting is “MID”.

1.Press and hold the [DISP] button for 1 sec- ond or longer to switch to the display adjust mode.

2.Turn the [SEARCH] knob to select “S/A SENSE”.

3.Turn the [A-MODE] knob to select from “LOW”, “MID” or “HIGH”.

4.Press the [DISP] button to return to the previ- ous mode.

Setting the speed of the spectrum analyzer display

∗The factory default setting is “MID”.

1.Press and hold the [DISP] button for 1 sec- ond or longer to switch to the display adjust mode.

2.Turn the [SEARCH] knob to select “S/A SPEED”.

3.Turn the [A-MODE] knob to select from “LOW”, “MID” or “HIGH”.

4.Press the [DISP] button to return to the previ- ous mode.

1.Press and hold the [DISP] button for 1 sec- ond or longer to switch to the display adjust mode.

2.Turn the [SEARCH] knob to select “SCRN SVR”.

3.Turn the [A-MODE] knob to select “ON” or “OFF”.

4.Press the [DISP] button to return to the previ- ous mode.

Entering MESSAGE INFORMATION

When “ON” is selected for the screen saver setting, you can change the contents of the message.

∗Up to 30 characters can be entered.

∗The factory default setting is “Welcome to Clarion”.

1.Press and hold the [DISP] button for 1 sec- ond or longer to switch to the display adjust mode.

2.Turn the [SEARCH] knob to select “MSG INPUT”.

3.Press the [SEARCH] knob.

4.Turn the [SEARCH] knob to move the cursor.

5.Press the [BAND] button to select a character. Each time you press the [BAND] button, the character changes in the following orders:

Capital letters ➜ Small letters ➜ Numbers and Symbols ➜ Umlaut ➜ Capital letters…

6.Turn the [A-MODE] knob to select the de- sired character.

7.Repeat steps 4 to 6 to enter up to 30 charac- ters for message.

WXZ466MP 19