Clarity RC100 Chapter Installation, Battery included with RC200 Speakerphone, Remote Transmitter

Figure 3 – battery compartment

CHAPTER 4

INSTALLATION

A. Battery (included with RC200)

Speakerphone

Six "AA" size,

1. Nickel Metal Hydride (Ni-MH) recharge- able batteries are

used for back–up during a power out-

age (Fig 3).They power the for approximatelyRC

5 hours. DO NOT USE ALKALINE

BATTERIES, they will damage your equipment.

Remote Transmitter

Install the "23A" size 12V alkaline cigarette

2. lighter battery in the Remote Transmitter (included) as shown (Fig 4).With normal usage, it lasts 6–12 months. If the power indicator light is faint or does not come on when the button is pressed, replace the battery.The Remote Transmitter has an operating range of up to 40 feet.

Power indicator

Jack for accessory switch

	Thread both
Battery	ends of necklace
	through hole and
compartment	tie a small knot.
	(optional)

Figure 4 – Remote Transmitter

B. Connections

Figure 5 – Connection of phone line and

	AC adapter
1.	Connect the phone line and AC adapter
	as shown.	if
2.	Set the tone/pulse selector (T/P) to T
	you have touch tone service, set to P if
	you have pulse dialing (rotary). (See Fig 2)

The can be placed on a desk, or mounted

on theRCwall. Do not put the on or next to

metal surfaces, computers, televisions,RC radios, microwaves, or other electrical equipment that can cause interference to the wireless signal from the Remote Transmitter.

C. Setting up your RC

The comes with the following operatingRC settings from the factory:

Scan rate is 5 seconds per memory

1. location.

Voice activated answering (RC200

2. only) is off.

Unanswered call indicator is on.

3. Voice mail indicator (RC200 only) is

4. off.

Tone/pulse switch set to Tone.

5. Ring volume set to Hi.

6. "0" (operator) is programmed into first

7. memory location of M

8. Remote flash switch (RC2001. only) is off.

4