Clark Synthesis TA0.1 owner manual Placing/Mounting the Amplifier

SETTING UP YOUR AMPLIFIER

Placing/Mounting the Amplifier

The TA0.1 can be custom mounted for use in a variety of applications. By utilizing the pre-drilled holes in the mounting plate and the Remote Control, the user can mount the amplifier to almost any surface that provides 1) access to the Remote Control, 2) access to the Input/Output Panel and the AC Panel, 3) adequate ventilation for the amplifier, and 4) the ability to remove the amplifier or the Remote Control for servicing should that become necessary.

!CAUTION: Insure there are two (2) inches of clearance around the amplifier. DO NOT block the air vents. The amplifier will overheat if it does not have adequate ventilation.

The following steps describe the process for mounting your TA0.1 amplifier:

1.Determine where you want to mount/place the Remote Control.

2.Determine where you want to mount/place the amplifier.

3.Holding the Remote Control in the position you determined in #1, extend the wire from the Remote Control Interface box to the amplifier’s prospective location to determine if it can reach the amplifier without being overstretched or pinched in any way. If the wire cannot reach, or will be overstretched/pinched, adjustments will need to be made in the mounting location(s).

4.Once an adequate location for the Remote Control and the amplifier is found, attach the Remote Control using the pre-drilled holes in the corners of the box (see below). To avoid damaging the box, use 5/8 inch or M8 size flat washers.

5.Attach the amplifier to the mounting surface using the holes in the mounting plate (see below).

6.Connect the wire from the Remote Control to the amplifier and apply the initial settings described in the next section.

14 TA0.1 Amplifier www.clarksynthesis.com