Figure 7
Figure 8
Figure 9
HOW TO ASSEMBLE THE MACHINE
To assemble the machine, follow this procedure:
1.Remove the lower housing, vacuum bags, hose, wand, handle assembly, tank housing, and tool holder from the carton.
2.Remove the tank housing and the lower housing from the plastic bags.
3.Install the tank housing on the lower housing. To install the tank housing, follow this procedure:
a.Remove the two thumbscrews from the plastic bag. See figure 7.
b.Push the pivot bracket toward the front of the lower housing until it locks in position. See figure 8.
c.There are two hinges with slots on the bottom of the tank housing (1). See figure 9. Put the tank housing on the pivot bracket. Slide the tank housing back until the slots fit around the front edge of the pivot bracket.
d.Install the holding screws (2). See figure 9.
e.Connect the electrical plug in the lower housing to the receptacle in the tank housing.
4.Install the handle assembly to the tank housing. To install the handle assembly, follow this proce- dure:
a.Remove the thumbscrew from the handle tube.
b.Put the handle tube in the opening in the top of the tank housing (1).
c.Put the thumbscrew through the hole in the front of the tank housing (2).
d.Tighten the thumbscrew. To tighten the thumbscrew, turn it clockwise. See figure 10.
Figure 10
Page 16 | Clarke® CombiVac 12 & 14 Operator's Manual |