Danger!

14

RJ-45 - DB9 female adaptor

If your RS-232 control system uses a cable with a male DB9 connector, you will need to buy or build an adaptor to convert the RJ-45 female to a DB9 female. Standard RJ45-to-DB9 female connectors come with RJ-45 pins and colors as below. Wire the DB9 adaptor according to this diagram and table.

RJ-45

DB9

 

Pin-1 = Blue

Pin-1 = Brown

Pin-2 = Orange

Pin-2 = Green

Pin-3 = Black

Pin-3 = Yellow

Pin-4 = Red

Pin-4 = Orange

Pin-5

= Green

Pin-5 = Red

Pin-6

= Yellow

Pin-6 = Blue

Pin-7

= Brown

Pin-7

= NC

Pin-8

= White

Pin-8

= Black

 

 

Pin-9

= White

Remarks: The Cat 5 cable and connector that is used for the adaptor and plugs into the rear panel RJ-45 port must use pin-to-pin wiring.

8USB Port

The USB connector is used to host a USB stick for updating amplifier firmware, should that become necessary.

9AC Mains Input

An IEC standard power cord (supplied) is used with the AMP5. Plug the cord into the IEC receptacle on the rear panel, and the other end into a suitable wall outlet.

10AC Mains Fuse

Your Classé power amplifier has an AC mains fuse, accessible on the rear panel. If you suspect that your AC fuse has blown, disconnect your amplifier from the AC mains, as well as from its input connections and speaker connections, and refer to the appropriate item of the section enitled Troubleshooting.

Do not open your amplifier. There are no user-serviceable parts within this product.

Potentially dangerous voltages and current capabilities exist within your power amplifier, even when disconnected from AC mains. Do not attempt to open any portion of the amplifier’s cabinet. There are no user-serviceable parts inside your power amplifier. All service of this product must be referred to a qualified Classé dealer or distributor.

Page 14
Image 14
Classe Audio AMP5 owner manual RJ-45 DB9 female adaptor, USB Port, AC Mains Input, AC Mains Fuse